Clean Matic CL22, Руководство по эксплуатации

Страница: 12 / 116

12
5.4 - USE OF CORDS
If an extension cord is used, make sure that plug and receptacle are of a water-tight type. In
any case they must be raised from the ground in order to avoid possible contact with water.
Use only extension cables with the same number of conductors as those of the machine cable,
including the earthing cable, and with a suitable plug/socket for the cable used.
Only use extension cords for outdoor use. Said type of cable is marked "Suitable for outdoor
use." Store inside when not in use.
Do not use damaged extension cords. Cables should not be located near sources of heat or
sharp edges. Always disconnect the plug from the socket before removing the extension cord
from the product. Do not pull the cable to pull the plug out of the outlet. Do not touch the plug
or connections with wet hands.
Voltage
230÷240
230÷240
100
100
1,5
2,5
2,5
4
Up to 20 m
From 20 to 50 m
Up to 20 m
From 20 to 50 m
Length m Wire gauge
mm
2
EXTENSION CORD CHART
(EXCEPT FOR MODEL CL 11)
WARNING
USE OF INADEQUATE
EXTENSION CORDS
MAY CAUSE SAFETY
HAZARDS
5.5 - START-UP
- Before starting up and using the machine, make sure that it is positioned on the ground or
leaning against a stable support and that the resting surface is level or with a minimum slope.
- It is ESSENTIAL to ensure that the suction filter is clean before use. (see maintenance chap-
ter – 10.1 inlet filter).
1 - Open water supply.
2 - Hold the gun in the open position to allow the air to escape from the hose.
3 - Switch on the unit (fig. 3) and enjoy your work.
Attention! The water pressure at the outlet of the lance generates a force on itself; therefore,
grip the lance with both hands and with a secure grip.
- Switch off the machine when work is completed.
1 2 3