[J]
10
LOADING INSTRUCTIONS
1 . Pull opening latch to release the main body .
2 .
Push the main body down completely until it stops to ensure it is FULLY opened .
NOTE
: Make sure pinch rollers are recessed to completely open the insertion slot
[J]
.
NOTE
: The CLEANCut™ appliance is equipped with a security feature to prevent opera-
tion while the unit is opened.
3 . Lift dowel rod to remove from device
and dispose of empty cardboard tube
from previous use (if any) .
4 . Insert the dowel rod through the center
of a new paper towel roll .
5 .
Once paper towel roll is loaded
onto the dowl rod, place into the dowel cradle .
NOTE
: It is recommended that you place the roll into the cradle so that the paper comes
up from the bottom front of the roll
[SEE ILLUSTRATION K]
.
HOW TO USE
10 . Once spacers are set (if necessary), hold CLEANCut™ and mounting bracket up and
tighten screws into mounting holes to secure .
NOTE
: Always tighten screws to ensure the appliance does not move or shake during op-
eration. Be careful not to over-tighten the screws to avoid damaging the mounting bracket.
NOTE
: If you wish to conceal the power cord, drill a 3/8” hole through the bottom of the
cabinet fl oor at the rear and to the side of the cabinet. Now the power cord connector can
be run down through the 3/8” hole and connected to the power jack. The power adapter can
be plugged into a standard electrical outlet available inside the cabinet. If this outlet is not
available then one can be installed by a qualifi ed electrician.
11 . Plug power cord connector into the power jack in the back of the appliance . Plug into
standard electrical outlet . Extra cord should be hung over cord management hooks
behind unit
[SEE ILLUSTRATION E]
.
CAUTION
: Make sure power cord does not fall into the roll.
12 . Your CLEANCut™ appliance is now ready for use! For operating instructions, see the
HOW TO USE
section of this manual .
