[D]
7
FLAT CABINET INSTALLATION
IMPORTANT
: Always wear protective glasses or goggles to prevent injury when drilling.
1 . Clear counter top under installation
area to avoid getting dust or debris
on other appliances or items . Open
cabinets and remove contents to make
mounting easier .
2 . Fold mounting template along Flat Cabinet Fold Line . Place template under cabinet
with fold line even against the front edge, and tape securely in place
[D]
.
NOTE
: Use center line to align unit with center of cabinet if desired.
IMPORTANT
: Do not align screw holes on template with the partition between cabinets, as
this will prevent you from installing the appliance properly. Pay close attention to where the
drill holes will be set so as not to damage your cabinets during mounting. Drilling through your
cabinet’s partition may cause damage to cabinets and prevent proper installation.
3 . Drill from under the cabinet up . Drill holes through the 4 places marked on the
template using a 1⁄4-inch drill bit .
IMPORTANT
: Always ensure you are drilling straight up through the marked mounting
hole on the template. Drilling at an angle may prevent proper installation and may damage
cabinets if the drill bit pierces the partition.
4 . Once holes are drilled, remove tape and mounting template and save template with your
instructions in case you move or wish to remount at a later time .
5 . Wipe dust and debris off inside cabinet surface . Also, make sure under side of
cabinet is clean .
6 . Place a washer inside the cabinet over each of the 4 holes you drilled .
7 . Drop one of your screws through each of the washers covering the holes in the cabinet,
from inside the cabinet down .
8 . Hold CLEANCut™ and mounting bracket up and tighten screws into mounting
holes to secure .
NOTE
: Always tighten screws to ensure the appliance does not move or shake during op-
eration. Be careful not to over-tighten the screws to avoid damaging the mounting bracket.
