COMPRESSED AIR FITTINGS
The vacuum has the following compressed air requirements to function properly
• Compressed air must be clean, dry, and oil free to prevent blockage of the pneumatic system
• Compressed air line and fittings must have a minimum diameter of 1/2in
Compressed Air Plug (air in)
The Vacuum is supplied with a 1/2in stainless steel industrial interchange compressed air plug for connection to your compressed
air supply.
The Compressed Air Plug may be changed to another nominal 1/2in style if required
• Remove the compressed air plug with either a 7/8in deep socket or 7/8in open end wrench
• Install a new compressed air plug
Compressed Air Coupler (air out)
The Vacuum is supplied with a 1/4in brass high flow compatible industrial interchange compressed air coupler.
This coupler provides convenient pass through compressed air for an air tool connected to the vacuum.
The Compressed Air Coupler may be changed to another nominal 1/4in style if required
• Remove the compressed air coupler with a 3/4in open end wrench
• Install a new compressed air coupler
Repair or Warranty Contact
Clayton Associates, Inc.
•
1650 Oak Street
•
Lakewood, New Jersey 08701
•
P.+1-732-363-2100 F.+1-732-364-6084
www.DustlessMadeSimple.com
•
Page 4
DYNAMIC POWER CONTROL
1. Adjusting
the DPC (Dynamic Power Control)
• Vacuum power and compressed air consumption can be adjusted by turning the DPC with a large flat head screwdriver
• The DPC rotates 1-1/2 turns from fully closed to fully open
• Do not force the rotation past these limits
• Rotate the DPC clockwise to the fully closed position
• Rotate the DPC counterclockwise 1 full turn to the factory setting
• To increase vacuum power and compressed air consumption turn the DPC counter-clockwise up to an additional 1/2 turn
• To decrease vacuum power and compressed air consumption turn the DPC clockwise up to an additional 1/2 turn
Compressed Air Plug
(Air In)
Compressed Air Coupler
(Air Out)
