Safety instruction
The Lithium Power Supply (LPS) is classified as Class 9 hazardous material UN3480, a power
source with high energy density and dangerous materials in a closed metal case.
Installation must strictly follow the national safety regulations in compliance with the enclosure,
installation, creepage, clearance, casualty, markings, and segregation requirements of the end-use
application. Installation must be performed by professional installers only. Switch off the system
and check for hazardous voltages before altering any connection!
The Lithium Power Supply must be handled only by qualified and trained personnel.
The lowest protection degree of specific parts of the LPS is IP21. Ensure that the installation of the
Lithium Power Supply is in accordance with IP21 requirements.
This is a Class I product. Only connect 230VAC from a source that is connected to electrical
protective earth, including any extension cords between the source and the unit.
Especially keep these rules:
• Do not open the Lithium Power Supply.
• Do not discharge a new Lithium Power Supply before it has been fully charged.
• Charge only within the specified limits.
• Keep the LPS turned off when moving and installing.
• Do not mount the Lithium Power Supply upside down or on its sides.
• Check if the Lithium Power Supply has been damaged during transport.
• Do not put Lithium Power Supplies in serial or parallel.
• Do not place unprotection from the weather.
• Do not cover or block the fan or the air inlet to ensure the battery does not overheat.
• Do not let children or animals come in contact with the unit or power connections.
Dangers involved in case of fire:
• Danger of dust particle explosions
• Decomposition through fire or heat under development of toxic and cauterizing gases
• Combustion gasses which strongly irritate eyes and respiratory organs
General actions to be taken by the driver if these dangers occur:
• Turn off the engine.
• Put a warning signal on the road to warn others.
• Inform others about the danger and direct them to stand away from the wind direction.
• Call the police and fire department immediately and inform that lithium batteries (UN3480) are
on board.
Instruction for fire extinguishing:
• Extinguish with water, if possible, submerge lithium power supply completely in water
• Extinguishing with water will produce fluoride, phosphate, fluoride-oxide and carbon-oxide.
• Alternatively extinguish with a CO2 extinguisher.
NON SPILLABLE
LI-ION BATTERY
In the box
1 x LPS Charging Cable Neutrik - CEE 7/7
1 x AC Output (Neutrik Grey)
4 x Cable shoe covers
4 x M8 Screws
2 x M4 Screws
Index
Safety instruction .................................................................................................................................2
Introduction ..........................................................................................................................................3
Index .....................................................................................................................................................3
In the box ..............................................................................................................................................3
Mounting. ..............................................................................................................................................4
Power Cable ..........................................................................................................................................4
Transport ...............................................................................................................................................4
Storage .................................................................................................................................................4
Service ..................................................................................................................................................4
Disposal .................................................................................................................................................4
Installation and initial start ...................................................................................................................5
Certifications / Compliance .................................................................................................................5
Safety protections ................................................................................................................................5
Warranty ................................................................................................................................................6
Copyright ..............................................................................................................................................7
Specifications .......................................................................................................................................8
3
Introduction
All information and instructions in the present Safety instruction have been generated in
consideration of current standards, industry guidelines and our years of experience.
User guides are separate documents which can be found on www.ClaytonPower.com. The User
guides can provide you with further information about how to install LPS II in different setups and
operate the product with Clayton Power accessories.
