Claudgen ScreenZone RAC0603, Инструкция по установке и эксплуатации

Страница: 5 / 10

41001452 Iss 06
5
that the points of attachment to the building are
sound. Consultation with the consultant/architect or
owner of the building is recommended to ensure
that a sound, mechanically stable installation is
achieved.
Before fitting or wiring the air curtain, ensure the
outlet is facing the doorway as on the fig 1 and see
the general installation guidance notes.
Using a pozidrive screwdriver slacken the two M5
screws in the corners near air inlet side and remove
the two M5 screws in opposite corner near the out-
let. Slide the lid sideways until the keyhole slots
pass over the screw heads. The grille assembly can
now be removed from the case. (fig 3)
Each unit has 2 fixing brackets from which it is sus-
pended. The brackets may be removed to assist in
passing the air curtain through the recess then reat-
tached when in - situ.
Either drop rods or catenary wire can be used to
fasten the air curtain to the ceiling support structure.
The height between the ceiling face and the top of
the air curtain case needs to be adjusted to circa
140mm to enable the grille assembly to fit flush with
the ceiling. Adjust accordingly.
After fitting the product in the ceiling recess and ad-
justing the height to ensure that the grille sits flush
to the ceiling (when re - fitted) take the grille assem-
bly and refit using the screws removed.
4. Electrical Connections
Fig.8 Ca-
4.1 Electrical connections
Fig.7 Grille Earth lead
With grille removed, connect the electrical supply
and controls wiring to the appropriate terminals (see
relevant wiring diagram section).
The unit has four holes for the cable entry, two on
the top and two on the side. Cable entry may be
moved to alternative position if desired (see Fig.8
drawing).
An EARTH lead is connected to the lid from the unit
body via a push on connection at grille. When re-
placing the grille onto the unit ensure the EARTH
lead is re - connected. (see Fig.7 )
Electrical supply is 230/240V single phase, Neutral
and Earth. The maximum cable inlet size is 4mm².
3. Installation Details
Fig.4 Fixing points
Fig.5 Wire fixing
Fig.6 Rod fixing