Claudgen HE7230, Инструкция по установке и эксплуатации

Страница: 4 / 8

4
ENSURE THE AIR OUTLET OF HE7230 AND
HE7245 IS NEAREST TO THE WALL OR CORNER.
3.1 Mounting
The Claudgen recessed ceiling heaters are de-
signed to fit in place of a standard 600mm ceiling
panel.
IT IS ESSENTIAL THAT THE CEILING FRAME IS ADE-
QUATELY SUPPORTED TO SUPPORT THE WEIGHT OF THE
HEATER, OR THAT THE HEATER IS INDIVIDUALLY SUP-
PORTED. THERE IS PROVISION ON THE HEATER FOR
CHAIN OR WIRE, SUPPORT OR MOUNTING.
The weight of the HE7230/RX, HE7245/RX is 7kg
The weight of the HE7260/RX is 10kg
It is the sole responsibility of the installer to ensure
that the points of attachment to the building are
sound. Care must be taken to allow complete free
air movement into the inlet grilles of the unit to
ensure the correct working operation of the
heater. Carefully unpack the unit and control box.
The unit is supplied with a length of self-adhesive
foam strip. This can be cut into lengths and is to
be laid on the 4 sides of the ceiling frame . This
will ensure that the unit assembly is free from vi-
bration. The discharge grille and diffuser assem-
bly can now be fitted into the ceiling frame.
4.1 Electrical Connections.
These units are suitable for connection to a
230/240 Volt 50 Hz single phase supply.
The appliance shall be connected to the supply
via an appropriate switched fused double pole
isolator having a contact separation of greater
than 3mm. Test for correct operation and refit the
cover.
3. Installation Details.
Fig.1 Air discharge of HE7230/RX and HE7245/RX
Fig.2 Air discharge of HE7260/RX
TOP OR SIDE CABLE ENTRY
TERMINAL COVER
For connection to the mains supply it will be
necessary to open the terminal cover at the side/
back of the unit to connect the supply from the
controls prior to refitting the cover. Wire in accor-
dance to the wiring diagrams.
For safety reasons, a sound earth connection
must always be made to the unit before it is put to
use. The unit should be wired in accordance with
IEE Regulations for the Electrical Equipment of
Buildings.
4. Electrical Connections.
41001456 Iss 01
Fig.3 Mounting supports
The wire or chain used to mount the heater can be
attached to 4 of the M6 studs or the 4 x M6
threaded inserts as shown in diagram.