Clatronic BS 1302, Инструкция по эксплуатации

Страница: 33 / 58

33
BS1302_IM 08.03.16
Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on / off switch and
remove the plug from the socket.
2. Hold the cable to avoid wrapping.
3. Press the cable winding button and guide the cable.
Maintenance
Emptying the dust collector
Empty the dust collector once the collected dirt reaches the
MAX marking.
1. Disconnect the mains plug from the wall socket.
2. Press the button (7) to release the dust collector. Remove
the dust collector.
3. Empty the dust collector over a dustbin. In order to do so,
press the button on the dust collector to open the base
plate. (Page 4, Fig. B)
4. Then close the base plate again.
5. Attach the dust collector to the appliance. First position it
at the bottom of the appliance and then secure it with the
hook on top.
6. Check that the position of the dust collector is secure by
briefly lifting the appliance at its carrying handle.
The Filter System
Your appliance features 4 filters. The common dust bag
system has been replaced by a transparent dust collector.
The higher flow speed of the collector allows for heavy dirt
and smallest floating particles to be separated from the
“sucked-in air”.
It is thus not necessary to buy dust bags.
The filters must be cleaned periodically.
The filter unit (Page 4, Fig. C to H)
The filter unit is composed of:
• Nylon filter
• Filter fleece
• Central filter
• Pre-filter
• Fastening disk
CAUTION:
• Never wash the components in a washing machine or a
dishwasher!
• Do not use a hairdryer for drying.
• Operate the appliance again only when all components
are completely dry and have been installed correctly.
Proceed as follows to clean the filter unit:
1. Empty the dust container as described above. (Steps
1 - 3)
2. Disassembly of the filter unit
2.1. Turn the filter unit in the direction. (Fig. C)
2.2. Pull the filter unit from the dust container. (Fig. D)
2.3. Turn the fastening disk and pull it off. (Fig. E)
2.4. Pull the pre-filter from the central filter. (Fig. F)
2.5. Open the cover of the filter unit. (Fig. G)
2.6. Remove the nylon filter and the filter fleece. (Fig. H)
3. Clean all parts of the filter unit and the dust container
under running water. You may use a soft brush.
4. Allow all parts to dry completely in air.
5. Assembly of the filter unit
5.1. Insert the filter fleece and then the nylon filter into
the cover.
5.2. Close the cover. It must lock mechanically.
5.3. Set the pre-filter to the central filter.
NOTE:
The pre-filter has recesses of different sizes,
which match the tabs on the central filter.
5.4. Set the fastening disk onto the pre-filter and tighten
it by turning.
5.5. Replace the filter unit in the dust container: Set
the guide tab on the filter unit to the symbol.
Tighten the filter unit by turning it in the direction.
Outlet filter
The appliance is also equipped with an outlet filter.
It is located on the back of the appliance.
1. Push the lock (10) down and remove the ventilation grill.
2. Remove the filter insert and clean it as described above.
3. Place the completely dry filter back into the ventilation
grille.
4. Put the ventilation grille back on the appliance. Observe
the guide lugs. The ventilation grid must engage audibly.
Cleaning
WARNING:
• Before cleaning remove the mains lead from the socket.