12
B066
SAFER PLUG®
This product is equipped with a Safer Plug®; an advanced
safety device that helps detect electrical fires caused from
faulty outlets.
Overloading of outlets, adapters and surge protectors may
cause overheating, damage, and increase risk of fires. Safer
Plug® continuously monitors the temperature in the plug and
outlet and will turn off the heater to prevent unsafe outlet
overheating.
If the Safer Plug® cuts the power due to unsafe conditions it
will show an “ ”message on the screen. If this occurs the
Safer Plug® has prevented a potentially unsafe condition.
To reset the device if this occurs, first allow the plug to cool
down. Once the plug has cooled down, unplug the device
and wait 5 seconds, then plug back in and continue to use
normally.
If the Safer Plug® continues to activate your outlet may
be faulty. Check your heater cord and plug connections.
Faulty wall outlet connections or loose plugs can cause the
outlet or plug to overheat. Be sure the plug fits tight in the
outlet. Heaters draw more current than small appliances,
so overheating of the outlet may occur even if it has not
occurred with the use of other appliances. During use check
frequently to determine if your plug, outlet or faceplate is
HOT! If so, discontinue use of the heater and have a qualified
electrician check and/or replace the faulty outlet(s).
This product is equipped with a Safer Sensor™; an advanced
safety device that helps prevent heaters from being
accidently covered or blocked causing a potentially unsafe
condition.
The SAFER SENSOR detects if an object is too close to the
front of the heater potentially obstructing the air outlet. If
blocked, the SAFER SENSOR icon on the control panel will
flash, the heater will beep continuously, and then shut off.
Once the object has been moved, the icon will stop flashing,
the beeping will cease, and the heater will turn back on.
To disable the Proximity Sensor safety function press and
hold the ECO MODE button for 10 seconds. Once disabled
the SAFER SENSOR icon will remain lit indicating it is disabled.
Repeat this step to re-enable the function.
SAFER SENSOR™
Patent Pending
Patent Pending
