CLAS PE 6001, Руководство пользователя

Страница: 16 / 32

PE 6001
DOUBLE SCISSOR LIFT 3T
reference numbers.
- In the case of a standard installation, the control unit is close to the vehicle’s entry direction.
If it is positioned to the right, it is necessary to adjust also the oil pipe.
Oil pressure adjustment:
Add hydraulic oil as instructed.
After installing the lift, as required in Picture 4, and after connecting the hydraulic /electrical circuits
and any other pneumatic circuits, proceed as follows:
open the hydraulic oil tank and add 18L of hydraulic oil - type H46 - into it. The hydraulic
oil is not supplied by the manufacturer.
Make sure the hydraulic oil does not have impurities to avoid the malfunction of the
solenoid valve.
activate the «MAIN SWITCH» button to turn on the power, by clicking the ‘UP’ button
proceed checking that the engine rotates clockwise ( by looking down), if it’s not turn off
the «MAIN SWITCH» and then change the motor phase.
When power is switched on, the high voltage in the control box is activated. Only
authorized person can do such operation.
Pressing the ‘UP’ button the engine starts to bring the platforms to the maximum height that can
be reached.
Open the control box door, and press the “UP” and “SB4» button, as shown in picture 20, for a few
minutes until the all the air outflow from the hydraulic circuit.
Press the ‘DOWN’ button until the platforms stop at the minimum permissible height and then
press the « SECOND DOWN» button, in this way the platforms will reach the closing position.
The oil pressure adjustment is now completed.
1)
2)
3)
4)
Picture 20 The level setting button (SB4)
CALIBRATION