CLAS OE 5036, Руководство пользователя

Страница: 11 / 16

OE 5036
INFRARED THERMOMETER -38°/520°
3. Battery Charge Level lndicator
lndicates that the batteries are high and measurements are possible.
lndicates that the batteries are low and should be replaced immediately although
measurements are still possible.
lndicates that the batteries are exhausted.
4. Scanned Temperature
5. Reference Temperature lndicator
6. Arrowhead lcons for lndicating the Threshold
7. Reference Temperature
8. Units
When the battery charge level indicator shows the batteries are low and should be
replaced immediately.
Wait until the thermometer turns off automatically, then remove the battery caver by moving
it downwards. Replace the old batteries with new ones of the same type, make sure that the
polarity connections are correct. Reinstall the battery caver.
1. Hold the thermometer and point it toward the target to be measured. Pull and hold the
trigger for at least 1 second to start measuring. When the thermometer is in measurement
state, the backlight and the laser are on, and the screen shows the icon «SCAN». When you
release the trigger, the thermometer sounds 3 beeps and the laser turns off and the last
temperature reading is held on the screen. If you have not operated the thermometer for
about 15 seconds, the backlight will turn off automatically, and, If you have not operated the
thermometer for about 1 minute, the thermometer will turn off automatically.
2. When the thermometer is in measurement state ( the trigger is pulled and held ), you can
press the «
» Button to set the reference temperature, which is shown on the secondary
display (the lower display).
INSTALLING BATTERY
OPERATING INSTRUCTIONS