5
English
Symbols on the display
The data hold function is activated.
The sleep mode is activated.
Indicates a negative reading.
Indicator for AC measurement.
Indicator for DC measurement.
The Autorange is activated (meter automatically selects the range with
best resolution).
The reading is too high for this measuring range.
Indicator for the diode test.
The continuity buzzer is activated.
Low battery warning – replace the battery.
REL is activated, the stored value minus the present value is displayed.
Resistance, Ω (ohm), kΩ (kiloohm), MΩ (megaohm).
Voltage, mV (millivolt), V (volt).
Frequency, Hz (hertz), kHz (kilohertz).
Operating instructions
Warning!
• Before measuring voltage, always make sure that the meter is set to the correct
function range and not set to resistance or diode test mode.
• Use extreme caution when measuring voltages over 60 V, especially when
the objects being measured have high power outputs.
• Make sure that the circuit to be tested is not conducting any current before
performing resistance measurements or diode tests.
• Always ensure that the correct function and range is selected.
• Take extreme care when using the meter on an inductive component such
as a transformer, relay coils and the like. High voltage may be induced at
the measuring points if an open circuit occurs.
• Make sure that the test leads are in good condition with no damage to
the insulation.
• Take care not to exceed the overload limits given in the specifications.
