6
English
Dual time setting
Setting a dual time zone:
1. Hold in [
▲
] until appears in the display.
2. Make sure that the temperature is displayed in the lower right-hand corner. If not,
then press [ mode ] until the temperature is displayed.
3. Hold in [ mode ] until the hours display begins to flash.
4. Press or hold in [
▲
] or [
▼
] to set the hours.
Note:
Minutes cannot be set for dual time zones. Time zones are only shown in
hour differences.
5. Push [ mode ] to save your settings.
6. Hold in [
▲
] to switch between dual time zone or normal clock display.
Dual time display
The display can be configured for dual time display.
1. Press [ mode ] until
appears in the lower right-hand corner.
2. Hold in [ mode ] until the hours display begins to flash.
3. Press or hold in [
▲
] or [
▼
] to set the hours.
4. Press [ mode ] again until the minutes display begins to flash.
5. Press or hold in [
▲
] or [
▼
] to set the minutes.
6. Push [ mode ] to save your settings.
Display backlight
Press [ snooze • light ] to turn on the backlight. The backlight has a 5 sec duration time.
Time projection
Note:
The clock must be connected to the mains for the projector clock to work.
1. Press [ snooze • light ] to turn the projector on. The projector has a 5 sec duration time.
2. To turn on time projection permanently, slide the switch (9) forward in the direction
of the arrow.
3. Press [ flip ] to flip the projection 180º.
4. To turn off permanent time projection, slide the switch back.
Temperature unit selection ºC/ºF
Press[ ºC/ºF, wave ] to select the temperature unit to be shown.
Manual time signal scan
Press [ ºC/ºF, wave ] until begins to flash.
Care and maintenance
Clean the product using a lightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
