Installation
The heater must be installed in a location at least
30 cm away from the closest surface.
1. Turn the heater upside down and place it on a firm surface that will not scratch the paint finish.
2. Fasten the feet onto the underside of the heater using the four screws.
Instructions for use
1. Plug the mains lead into a wall socket.
2. Press
to switch the heater on/off. The heater will beep and the standby button will illuminate.
3. Press to switch the heater on or put it into standby mode. The heater will come on with the latest saved
settings. If the temperature of the room is lower than the temperature on the display,
the heat mode indicator will illuminate and the heater will begin to heat.
Power settings
Press
. The power setting will be shown on the display. Press
to change the power setting according to the
following sequence:
H1
H2
AF
1250 W
2000 W
Anti-frost mode
7 °C ± 3 °C (cannot be changed).
Temperature
Press to increase the temperature and to lower it. The temperature setting range is 10–35 °C.
Shutdown timer
Press and hold down
to enter the settings mode , will appear on the display.
1. Press
and
to set the number of hours the heater is to remain on for before it shuts down (0–24 hours).
2. Confirm by pressing
.
will illuminate to indicate that the shutdown timer is activated.
EN
G
LI
S
H
