4
E
nglish
Instructions for use
Placement
• Place the fan heater on a hard and level surface.
• Never place the fan heater on soft surfaces such as beds, blankets or thick rugs, etc.
• Do not place the fan heater in a bathroom, laundry room, or close to the bath or shower.
• Do not use the fan heater in damp or dusty environments.
• Place the fan heater some distance away from furniture, curtains and other flammable objects.
Make sure that fan heater is at least 90 cm from combustible materials.
On
1. Plug the mains lead into a wall socket.
2. Turn the power switch on which is located on the back of the fan heater.
3. Press [
l ] (10) to switch the fan heater on. The indicator light (9) will
come on.
4. Press [
Ι
], [
ΙΙ
] or [
ΙΙΙ
].
The thermostat knob must be turned in order to activate the Warm Air modes.
Off
If the fan heater has been running on Cool Air mode:
Press [0]. This turns off the fan heater and the indicator light goes off.
Bear in mind that the power switch on the back of the fan heater is still on.
If the fan heater has been running on Warm Air mode:
Press [0]. The fan heater continues to run in Cool Down mode for approx. 30 seconds (the indicator
light flashes) and then turns off automatically.
Bear in mind that the power switch on the back of the fan heater is still on.
If you turn off the fan heater using the power switch on the back, then Cool Down mode will
not be activated. When you turn on the fan heater again with the power switch, the fan heater
will start in the same mode that was running before you turned it off.
Thermostat knob
Note:
Bear in mind that factors such as the size of the room, the outside temperature and how well
the building is insulated, all affect the ability of the fan heater to warm up the room. If the room is too
large the ability of the heater to warm it up to the desired temperature may be insufficient.
The temperature range of the thermostat is approx. 5–35 °C. To heat a room to the desired temperature,
do as follows:
1. Turn the thermostat knob to the maximum setting.
2. Slowly turn back the thermostat knob when the desired room temperature has been reached.
Stop turning the thermostat knob when a click is heard. The fan heater will go into Cool Down
mode for 30 seconds and then switch off. The indicator light will shine with a steady glow when
the Cool Down mode has been activated after the thermostat has turned off the fan heater.
3. No further adjustment is required. The fan heater will then automatically turn on once
the temperature goes below the setting and turn off once the set temperature is reached.
