9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
FITTING THE CHISEL
1. Select which chisel is best
suited to the task. A
selection of chisels is
supplied as shown.
2. First remove the retaining spring
from the nose by unscrewing it.
• Use the inboard lug to gain
purchase.
3. Insert the chisel into the air
hammer as shown.
4. Replace the retaining spring.
• Use the lugs to help tighten.
USING THE AIR HAMMER
1. Hold the tool firmly, then bring the
tool towards the work at an angle
of approximately 60-70 degrees.
2. Squeeze the trigger with the chisel
in light contact with the work.
• The chisel speed is controlled by
squeezing the trigger.
3. Move slowly across the work
surface. To remove scale, rust or
other contaminants, only a light force should be required.
4. Release the trigger to stop operation whilst maintaining contact with the
work.
NOTE:
The air tool may operate briefly after the trigger is released.
Содержание X-Pro CAT200
Страница 16: ......
