7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
•
NEVER reach around or over the
saw blade. NEVER reach for a
workpiece until the saw blade has
completely stopped.
•
Make sure that the blade and
flanges are clean and the
recessed sides of the collar are
against the blade. Tighten the
arbor nut securely.
•
Keep the saw blade sharp and
properly set.
•
Make sure that the riving knife is
adjusted to the correct distance
from the blade.
•
Never operate the saw without the
guards in place.
•
Do not use abrasive discs or
diamond cutting wheels.
•
Rebating, slotting or grooving is not
allowed.
•
Do not use a moulding head cutter
with this saw.
•
Remove the rip fence when
crosscutting. Never use the rip
fence as a cut-off gauge when
crosscutting.
•
Knock out any loose knots from the
workpiece before you begin to
cut.
•
Provide adequate support to the
rear and the sides of the saw table
for long or wide workpieces.
•
Never leave the machine running
unattended. Turn the power off
and do not leave the machine
until it comes to a complete stop.
•
Before using the tool on an actual
workpiece, let it run for a while.
Watch for vibration or wobbling
that could indicate poor
installation or a poorly balanced
blade.
•
Always hold work firmly against the
mitre gauge or rip fence.
•
NEVER stand or have any part of
your body in line with the path of
the saw blade. keep your hands
out of the saw blade path.
•
Feed work into the blade against
the direction of rotation only.
•
NEVER attempt to free a stalled
saw blade without first turning the
saw off. Turn the power switch off
immediately to prevent motor
damage.
•
Avoid awkward operations and
hand positions where a sudden slip
could cause your hand to move
into the saw blade.
•
Avoid abrupt, fast feeding. Feed as
slowly as possible when cutting
hard workpieces. Do not bend or
twist the workpiece while feeding.
If you stall or jam the blade in the
workpiece, turn the table saw off
immediately. Unplug the table
saw. Then clear the jam.
•
NEVER remove cut-off pieces near
the blade or touch the blade
guard while the blade is running.
SAW BLADES
1. The maximum speed of the saw
blade must always be equal to or
greater than the no-load speed of
the table saw as specified on the
rating plate.
2. Do not use saw blades which are
damaged or deformed.
Содержание Woodworker CTS14
Страница 28: ......
