18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OVERLOAD RESET BUTTON
This table saw has a thermal overload
protection device.
If the saw gets too hot, the thermal
overload device cuts the power
which prevents damage to the
motor.
If the thermal overload device
operates, let the motor cool down for
5 minutes and push the reset button
located just below the ON (I) button
If you start the saw and the overload cutout operates again, disconnect from
the power supply and have your table saw examined by a qualified service
agent.
CUTTING TIPS
RIPPING CUTS
Ripping is when you use the saw to cut along the grain of the wood.
The parallel fence must always be used when making ripping cuts.
1. Press one edge of the workpiece
against the parallel fence while
the flat side lies on the saw table.
• The blade guard must always
be lowered over the workpiece
and blade.
• When you make a ripping cut,
never stand in line with the
blade.
2. Set the parallel fence in
accordance with the workpiece height and the desired width.
3. Switch on the saw.
4. Place your hands (with fingers closed) flat on the workpiece and push the
workpiece along the parallel fence towards the blade.
5. Guide at the side with your left or right hand (depending on the position of
the parallel fence) only as far as the front edge of the guard hood.
Содержание Woodworker CTS14
Страница 28: ......
