8
1.
The switch panel incorporates the ON and OFF switches.
2
Your saw also teatures an Overload Protection device, so that it the motor is overloaded (due to
feed pressure being too great, dull blade or low voltage), the Overload Relay will intervene, and
the motor will automatically cut out.
3.
A Dust Extraction Outlet is provided at the rear of the machine. A vacuum extractor with a suitable
fiexible hose (58mm dia.), may be connected and used either permanently or intermiffently as
required.
4.
The Table is provided with two slots, one each side ot the saw blade, running across its entire
width. These slots are tor use with the Mitre Gauge, when cross cuffing either square or mitres, and
is explained under ‘Operation’. A scale on the Mitre Gauge indicates the angle at which the
workpiece is being mitred.
5.
Four holes are provided in the base so that the saw may be bolted to a workbench or stand.
Please note that the machine MUST be tirmly secured to either a workbench, or a support to
ensure its complete stability. This is explained in detail under ‘Mounting the Saw’ on page 12.
FEATURES
