Clarke STRONG-ARM CSA50FP, Руководство по эксплуатации и техническому обслуживанию

Страница: 12 / 20

12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
ROUTINELY
• A visual inspection must be made before each use of the press,
checking for leaking hydraulic fluid and damaged, loose, or missing
parts. Clean off any foreign material from the ram carriage. Keep the
protective screen clean at all times.
• If the press appears to be damaged in any way, is found to be badly
worn, or operates abnormally SHOULD BE REMOVED FROM SERVICE until
the necessary repairs are made.
• If the press is not to be used for any length of time, store it with the ram
piston withdrawn to protect the surface of the moving parts.
PERIODICALLY
• Check the press to make sure all bolts are tight and inspect for cracked
welds, bent, loose or missing parts.
• Owners and/or users should be aware that repair of this equipment
requires specialised knowledge and facilities. It is recommended that a
thorough annual inspection of the press be made and that any
defective parts be replaced with genuine Clarke parts.
• Check the hydraulic
connections for leaks. Replace
or properly repair any
damaged or leaking hydraulic
components before using. In
the event of leaking seals. Oil
can be topped up via the filler
plug on the top of the pump
after removing the pump
cover.
• Oil should be level with the
bottom of the hole. If necessary top up with CLARKE hydraulic oil, Part
No. 3050830.
This task is carried out with the ram fully retracted.
• If any rust is apparent it must be removed completely and the paint
restored.
DISPOSAL OF UNWANTED MATERIALS
One of the most damaging sources of environmental pollution is oil products.
Never throw away used oil with domestic refuse or flush it down a sink or drain.