Clarke Strong-Arm 7611011, Сборка и инструкция пользователя

Страница: 10 / 20

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
OPERATION
RAISING THE JIB
IMPORTANT: Make sure that the hook is directly above the point of lift, which
in turn is directly above the centre of gravity of the load.
1. Close the operating valve by
turning it fully clockwise.
2. Pump the handle until the crane
reaches the desired height.
LOWERING THE JIB
1. Turn the valve anticlockwise VERY
SLOWLY.
• The speed of lowering is
controlled by how much you
turn the valve.
EXTENDING THE JIB
1. Lift the jib to a horizontal position.
2. Remove the locating pin.
3. Reposition the jib extension to the
desired length.
• The hole near the end of the jib
extension will match the hole in
the jib according to the weight
being lifted. These are clearly
marked.
4. Replace the locating pin.
5. Store the operating handle in the socket provided when not in use.
WARNING: IT IS ESSENTIAL THAT THE ARM LOCKING PINS ARE IN PLACE
BEFORE ATTEMPTING ANY LIFTING TASKS. FAILURE TO INSTALL THESE
WOULD RESULT IN THE CRANE TIPPING FORWARD WHEN SUBJECTED TO
ANY LOAD.