Clarke Strong-Arm 7611011, Сборка и инструкция пользователя

Страница: 9 / 20

9
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
15. Bolt the hook assembly through
the hole on the jib extension using
the 90 mm bolt, washer, lock
washer and nut.
16. Connect the handle to the rear of
the main support post using the
two remaining bolts and lock
washers.
17. Ensure that all weight is spread
evenly across all sections, making
sure that all castors are on level
ground and that the assembly is
sitting square and true. Tighten all
nuts and bolts.
18. Store the operating handle in the
holder on the column.
PURGING THE HYDRAULIC SYSTEM
During transit or storage, it is possible that an air pocket may have developed
within the hydraulic ram and the ram action may therefore appear to be
‘spongy’. As the ram is self bleeding, any air will be dispelled and the ram
action normalised by fully raising and lowering the jib a few times.
Should the jib not reach its full height, the oil level should be checked, as
described in the Maintenance section.