c. CONDOR Pressure Switch Type MDR3
The cover is removed by unscrewing the two securing screws - one at each side,
and pulling off the cover complete with rotary switch.
A. PRESSURE ADJUSTMENT:
To increase the cutout pressure, turn the hexagon (A) on top of the pressure switch
clockwise using a screwdriver.
To reduce the cut out pressure, turn it anticlockwise.
B. RANGE ADJUSTMENT:
Pressure differential between cut in and cutout, is preset and should not tampered
with.
ENGINE DRIVEN MACHINES
(Except CFP9BH - see page 12)
Air Governor
-
Pressure unloading genie
1.
Air Delivery Pipe from Compressor Pump.
2.
Bleed Valve
3.
Exhaust Filter
4.
Pressure Adjustment Knob
5.
Lock Nut.
To adjust pressure slacken lock nut (5).Turn pressure adjusting knob (4) clockwise
to increase pressure,anti-clockwise to decrease. Tighten lock nut (5) when correct
pressure isobtained.
WARNING:
Do not exceed the maximum working pressure of the machine, as marked on
the CLARKE AIR specification plate.
Fig.5
An information sheet
for this component is
provided with the
m a c h i n e ’ s
documentation
11
