Clarke MIG 240, Инструкция по эксплуатации и техническому обслуживанию

Страница: 10 / 28

10
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
THE CONTROL PANEL
1. Wire speed control knob. As a general rule, a higher current requires a
higher wire speed.
2. Current setting dial . Provides 6 increasing power levels.
3. Power ON/OFF switch. When the power is ON the green switch will be
illuminated. When the welder is no longer required, the Power On/Off switch
should be switched to the OFF position and the welder should be
disconnected from the power supply.
4. Thermal overload light. If the duty cycle is exceeded as a result of welding
for too long with a high current, the overload light will illuminate and the
welder will turn off. When the welder has cooled down (approx. 5 to 10
minutes), the power will be restored and welding can recommence.
Dial Setting Welding Current in Amps
1 50A
2 75A
3 100A
4 130A
5 180A
6 240A