8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
INSTALLATION
1. Provide a propane supply system (see Propane Gas Supply).
2. Connect POL (Prest-o-Lite) fitting
on hose/regulator assembly to the
propane tank(s).
• Turn POL fitting anti-clockwise
into the threads on the tank.
Tighten firmly using a wrench.
IMPORTANT: Position the regulator so
that the hose leaving the regulator is
in a horizontal position. This places
the regulator vent in the proper
position to protect it from the weather.
3. Connect the hose to the valve
inlet. Tighten firmly using a
wrench.
IMPORTANT: Use extra hose or piping
if needed between hose/regulator
assembly and propane tank. You
must use the regulator supplied with
heater.
4. Open the propane supply valve
on the propane tank(s) slowly.
NOTE:
If the supply valve is not opened slowly, the check valve on the
propane tank will activate and stop gas flow. If this happens, close the
propane supply valve and open again slowly.
5. Check all connections for leaks. Apply a mixture of liquid soap and water
to all gas joints. Bubbles forming show a leak that must be corrected.
6. Close the propane supply valve.
WARNING: READ AND UNDERSTAND THE WARNINGS IN THE SAFETY
INFORMATION SECTION, PAGE 3. THEY ARE NEEDED TO SAFELY OPERATE
THIS HEATER. FOLLOW ALL LOCAL REGULATIONS WHEN USING THIS
HEATER.
WARNING: TEST ALL GAS PIPING AND CONNECTIONS FOR LEAKS AFTER
INSTALLATION OR SERVICING. NEVER USE AN OPEN FLAME TO CHECK
FOR A LEAK. APPLY A MIXTURE OF LIQUID SOAP AND WATER TO ALL
JOINTS. BUBBLES FORMING SHOW A LEAK. CORRECT ALL LEAKS AT ONCE.
Содержание Little Devil II
Страница 16: ......
