Clarke Little Devil II, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 16

12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
TROUBLESHOOTING
WARNING: NEVER SERVI C E THE HEATER WHILE IT IS PLUGGED IN ,
CONNE C TED TO PROPANE SUPPLY , OPERATING OR HOT. SEVERE BURNS
AND ELECTRICAL SHOCK CAN OCCUR.
OBSERVED FAULT POSSIBLE CAUSE REMEDY
Fan does not
turn when
heater
is
plugged in
No electrical power to the
heater Check voltage to
electrical outlet. If voltage
is good, check heater
power cable for breaks
Structural damage Return to your dealer for
repair.
Defective motor Return to your dealer for
repair.
H eater will not
ignite
User did not follow
installation or operation
instructions properly Repeat installation and
operation instructions. See
Installation and Starting,
page 8+9
No spark at ignitor. If no
spark seen, the fault may
be:
A) Loose or disconnected
ignitor wire
B) Wrong spark gap
C) Piezo ignitor loose
D) Bad ignitor electrode
A) Check ignitor wire.
Tighten or reattach loose
ignitor wire.
B) Set gap between
ignitor electrode and
target plate to 0.17" (0.43
cm)
C) Tighten nut holding
piezo ignitor to base of
heater
D) Replace ignitor
electrode.
If you see a spark at the
ignitor have the heater
serviced by a qualified
service person.