11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ALARMS
If the clamps are wrongly connected
to the battery, the screen will show
“
WARNING - CLAMPS
REVERSED”
check all the connections
immediately
.
The polarity is reversed so you need
to disconnect the unit and reverse
the clamps. Turn the unit back on
and resume operation.
If the clamps are accidently touched
together there is no alarm as the unit is protected against this situation.
USING THE OVERRIDE BUTTON
When vehicle's battery is completely dead the jump starter will not detect
battery voltage automatically. You will need determine the working voltage
and “override” the jump start.
1. Determine the voltage of the battery by referring to the vehicle owners
manual and make sure that the output voltage of the jump starter is correct.
2. Confirm the correct voltage of electrical system you are going to jump-
starting is 12V or 24V.
3. Turn off the vehicle ignition switch and all accessories (lights, radio, climate
control, etc.)
4. Connect the red Positive Battery Clamp to vehicle's positive battery
terminal. Then connect the black Negative Battery Clamp to the vehicles
negative battery terminal.
5. Make sure all connections are correct.
6. Press the Override button.
7. Press and hold the correct voltage button that matches your vehicle for
about 2 seconds.
• The screen will show “JUMP START READY” at the voltage you have
selected.
8. Crank the engine within 30 seconds.
9. If the vehicle does not start after 5 to 8 seconds, stop, and wait a minute
before trying again.
WARNING: DO NOT USE OVERRIDE BUTTON UNLESS THE JUMP STARTER
FAILED TO DETECT VEHICLE'S BATTERY WORKING VOLTAGE.
Содержание JS1224Li
Страница 16: ......
