9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING YOUR PRESSURE WASHER
1. Turn the water supply on, making sure that the tap is fully open.
2. Plug the mains power cable into the electricity supply.
3. Release the trigger lock if it is
locked
• Push the button from the other
side if needed.
4. Press the section of the On/Off
switch marked “I” to start the
motor.
• The pressure washer is now
ready for use.
• Make sure that you have a firm
footing and are also holding
the gun and spray lance firmly.
The lance and gun will kick
back when in use.
5. Pull the trigger on the gun to start water flow.
INTERRUPTING OPERATION
1. Release the trigger.
2. Engage the trigger lock.
• The pressure washer is fitted with a total stop system to protect the
motor when in use. When the trigger is released the motor will stop.
When the trigger is squeezed the motor will start up again.
3. During longer breaks (more than 5 minutes), turn the appliance off. See
page 12.
WARNING: FAILURE TO TURN ON THE WATER COULD CAUSE DAMAGE TO
THE PRESSURE WASHER.
