5
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ELECRICAL CONNECTIONS
Before switching the product on, make sure that the voltage of your electricity
supply is the same as that indicated on the rating plate. This product is
designed to operate on 230VAC 1ph 50Hz. Connecting it to any other power
source may cause damage.
Connect the mains lead to a suitably fused 230V, 1 phase electrical supply via
a 16 Amp inductrial 3-pin connector (to BSEN 60309-1/2).
IMPORTANT: A domestic 13Amp plug MUST NOT be fitted to this appliance.
The electrical supply connection shall be made by a suitably qualified
electrician and comply with IEC 60364-1.
As the colours of the wires in the power cable of this product may not
correspond with the markings on the terminals of your plug, proceed as
follows.
If the colours of the wires in the power cable of this product do not correspond
with the markings on the terminals of your plug, proceed as follows.
• The wire which is coloured
Blue
must be connected to the terminal
which is marked
N
.
• The wire which is coloured
Brown
must be connected to the terminal
which is marked
L
.
• The wire which is coloured
Yellow and Green
must be connected to the
terminal which is marked
E
or
or
coloured
Green
.
We strongly recommend that this machine is connected to the mains supply
via a Residual Current Device (RCD).
FUSE RATING
The fuse rating for this pressure washer is 16Amps.
EXTENSION CABLES
If an extension cable is used, always ensure it is fully unwound. When used
outdoors, ensure that the extension cable is specifically designed for outdoor
use. Ensure that the cable is rated for the voltage and amperage of the
machine.
If in any doubt, consult a qualified electrician. DO NOT attempt any repairs
yourself.
WARNING! Read these electrical safety instructions thoroughly
before connecting the product to the mains supply.
Содержание HLS130
Страница 32: ......
