13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• The lance and gun will kick back when the trigger is first pulled.
• If heating of the water is required, the burner will light up to produce hot
water at the required temperature.
• The pressure washer is now ready for use.
• The machine should always be attended during hot wash operation.
5. Having used the pressure washer with hot water, set the temperature
selector to the minimum temperature and allow it to run with cold water for
a few moments before switching off.
6. At the end of the working session, switch off at the start switch (C) and by
pulling the trigger, to allow any residual pressure to be released.
USING DETERGENT
The detergent is applied by twisting
the cap on the lance as shown to
produce a wider spray patern with
lower pressure, and then pulling the
trigger on the gun.
When the nozzle is adjusted to a high
pressure and a narrow spray patern,
the detergent flow is halted.
When the nozzle is adjusted to high pressure and a narrow spray patern, the
detergent flow is halted.
WARNING: IF OPERATING THE MACHINE WITH DETERGENT INCLUDING
CLARKE CLEANING PRODUCTS, TAKE CARE NOT TO SET THE MACHINE TO
OPERATING TEMPERATURES OF GREATER THAN 100
O
C.
CAUTION: IF YOUR EYES COME INTO CONTACT WITH ANY CLEANING
FLUIDS, RINSE THEM IMMEDIATELY WITH PLENTY OF FRESH CLEAN WATER
AND SEEK MEDICAL ADVICE IF REQUIRED.
Содержание HLS130
Страница 32: ......
