Page -6-
Clarke
®
Operator's Manual -Fusion 27 Battery Burnisher
WARNING:
Maintenance and repairs performed by unauthorized personnel could result in damage or
injury. Maintenance and repairs must be performed by authorized Clarke personnel only.
WARNING:
Any alterations or modifications of this machine could result in damage to the machine or
injury to the operator or other bystanders. Alterations or modifications not authorized by
the manufacturer voids any and all warranties and liabilities.
WARNING:
Electrical components of this machine can "short-out" if exposed to water or moisture.
Keep the electrical components of the machine dry. Wipe the machine down after each
use. For storage, keep the machine in a dry building.
WARNING:
Operating a machine without observing all labels and instructional information could result
in injury or damage. Read all machine labels before attempting to operate. Make sure all
of the labels and instructional information are attached or fastened to the machine. Get
replacement labels and plates from your Clarke distributor.
CAUTION:
Use of this machine to move other objects or to climb on could result in injury or damage.
Do not use this machine as a step or furniture. Do not ride on this machine.
CAUTION
:
Your machine warranty will be voided if anything other than genuine Clarke parts are used
on your machine. Always use Clarke parts for replacement.
SPECIFICATIONS:
Model Fusion 27
(01264A)
Motor, Pad
3 hp
Power Supply
36V 370 Ah
Dust Tank
1/2 gallon
Motor Traction
1/2 hp
Pad Speed
1500 rpm
Pad Pressure
50 lbs.
Speed, Forward
192 ft./min.
Speed, Reverse
167 ft./min.
Charger
36V 23A
Length
74"
Width - Machine
30"
Height
45"
Buffing Rate
26,000 Sq. ft /hr.
Buffing Swath
27"
Weight w/Batteries (370Ah) 1,150 lbs.
Shipping Weight
w/batteries (370Ah)
1,300 lbs.
Introduction & Machine Specifications
Introduction & Machine Specifications
Clarke’s newly designed Fusion 27 battery burnisher
is an efficient and superior floor burnishing machine . The
machine uses a pad to burnish a path 27 inches wide. The powder created by burnishing is collected by a dust
system.
The machine comes complete with six - 6 volt batteries, one on board battery charger, a pad driver and one
operator’s manual.
EN
EN
https://harrissupplyind.com - To Order Parts Call 608-268-8080