Clarke Fusion 27 01264A, Руководство оператора, Страница: 28 / 58

Page -28-
Clarke ®
Operator's Manual -Fusion 27 Battery Burnisher
Tuerca de ajuste de la presión de la almohadilla
PARTE POSTERIOR DE LA MÁQUINA
HOW OPERATE THE MACHINE
Pad Pressure Operation (Contiuned)
While operating the machine, you may notice that the
pad pressure meter moves from Yellow to Green to Red
to Green etc. This is due to the condition of the floor
being burnished. The more consistent the floor, the more
stable the reading on the meter.
Depending on the type of pad and the finish being used,
the pad pressure may need to be adjusted in order to
keep the pressure within specifications. Refer to the
"Pad Pressure Adjustments" instructions.
Pad Pressure Adjustments
1. Locate the pad pressure adjustment nut located under-
neath the machine between the rear casters. See
figure 9.
2. Using a 3/4" wrench (1/2 turn increments only), tighten
the nut to reduce the pad pressure or loosen the nut to
increase the pad pressure.
3. Run the machine for a few seconds in order to get a
reading from the pad pressure meter.
4. If adjustment is still needed, follow steps 2-3 until the
pad pressure meter stays within the "Green" band.
Operating the Machine
NOTE: Put the machine in the slow traverse speed (less
than 1/2 speed). Use the machine in an area that has
no furniture and objects until you can do the following:
1. Move the machine in a straight direction, forward and
backward.
2. Stop the machine safely.
3. Move the machine in a straight direction after you turn
the machine.
To move the machine, follow this procedure:
1. Turn the key switch “ON” position.
2. Press and hold the top of the head position switch until
you hear the actuator rachet.
3. To go forward, push the control handles toward the
machine. See figure 10.
4. To stop the machine, put the handles in the center
position.
5. To go backward, pull the handles away from the
machine. See figure 11.
6. To turn the machine, push the rear of the machine to the
side.
7. When you stop the machine, turn the key switch
"OFF".
Figure 10
'
Figure 11
Figure 9
Pad
Pressure Adjustment Nut
REAR OF MACHINE
EN
Pad Ecrou de réglage de la pression
ARRIERE DE LA MACHINE
https://harrissupplyind.com - To Order Parts Call 608-268-8080