Clarke Focus II Rider, Инструкция по эксплуатации, Страница: 8 / 64

A - 8 Focus
®
II Rider - 56091040 5/12
INSTRUCTIONS FOR USE A - ENGLISH
INSTALL THE BRUSHES (DISC SYSTEM)
CAUTION !
Turn the key switch off (O) and remove the key, before changing the brushes, and before opening any access panels.
1 Make sure the Scrub Deck is in the RAISED position. Make sure the Key Switch (A) is off (O).
2 See Figure 2. Remove both side skirt assemblies. NOTE: The skirts are held in place by two large Knobs (AA) . Loosen these knobs and slide the Skirt
Assemblies (AB) slightly forward and then off of the Scrub Deck.
3 Put a brush or pad driver (AC) under the scrub deck.
4 Align the slots in the brush gimbal with the lugs on the motor Gimbal (AD) .
5 Pull the brush up until the gimbal locks.
6 Repeat steps 3, 4 & 5 to install the second brush or pad driver.
To Remove:
1 Make sure the Scrub Deck (8) is in the RAISED position. Make sure the Key Switch (A) is off (O).
2 Remove the side skirt assemblies.
3 Push down on two sides of the brush or pad driver until the gimbals release.
FIGURE 2