Clarke Focus II Rider, Инструкция по эксплуатации, Страница: 11 / 64

5/12 A - 11 56091040 - Focus
®
II Rider
ENGLISH - A INSTRUCTIONS FOR USE
DETERGENT SYSTEM PREPARATION AND USE
COMMON INSTRUCTIONS:
See Figure 5.
Pressing and releasing the Detergent Switch (S) while the solution system is active will cause the detergent system to cycle through the available
detergent ratios one at a time. The system should be purged of previous detergent when switching to a different detergent. SERVICE NOTE: Move machine over
fl oor drain before purging because a small amount of detergent will be dispensed in the process.
To Purge When Changing Chemicals:
1 Disconnect and remove the Detergent Container (13) .
2 Turn the Key Switch (A) ON. Press and hold the Solution Control Switch (O) and the Detergent Control Switch (S) for 3 seconds. NOTE: Once activated the
purge process takes about 10 seconds. Normally one purge cycle is adequate to purge the system.
Detergent Ratio:
1 The factory default detergent ratio is 1:32. Each press of the Detergent Control Switch (S) will cycle through the available ratios (1:32, 1:50, 1:64, 1:100,
1:128, 1:150, 1:200, 1:256, 1:300, 1:400). Pressing the switch once more after 1:400 will turn off the detergent system. The Detergent Strength Indicator (F1)
starts under the RED Strength Symbol (H) when at a ratio of 1:32 and will move left as you cycle through the ratios and end up under the GREEN Strength
Symbol (H) when at a ratio of 1:400. If the machine is turned OFF and then back ON again, the last setting is remembered.
DETERGENT INSTRUCTIONS:
A Detergent Container (13) can be installed behind the Detergent Container Access Cover (12) in the operator’s compartment. When installing a new container,
remove the factory cap and place the container in the detergent box. Install the Adapter (AA) and the Cap (AB) as shown.
FIGURE 5
13
AA
AB
A
O
S
F2
F1
H
F
Press for 3 seconds to purge