8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE / SETUP
1. Clean the chain before sharpening. Wash it with a non-flammable solvent.
Do not use petrol. Dry the chain.
FITTING THE CHAIN
2. Lift up the chain stop and place
the chain in the sliding guide as
shown.
• Look at each tooth on the
chain and start with the most
worn tooth. Position this tooth
roughly in the centre of the
sliding guides. All other teeth will
be ground to the same depth.
ADJUST THE SHARPENING ANGLE
3. Loosen the locking wheel to allow
the chain holder assembly to turn.
4. Check with your chain
manufacturer to determine the
angle you need.
5. Rotate the chain holder assembly
to the angle required.
6. Tighten the locking wheel.
• Do not rotate the chain holder
assembly when the grinding disc is moving.
WARNING: MAKE SURE THE SHARPENER IS NOT CONNECTED TO THE
MAINS SUPPLY DURING SETUP.
Содержание ECSS2
Страница 17: ......
