Clarke Devil 1250(ss), Руководство по эксплуатации и техническому обслуживанию

Страница: 6 / 28

6
UNPACKING
When unpacking, check the heater for possible shipping damage. Should
any damage be apparent, please notify your Clarke dealer immediately.
Your heater is fully assembled,- only the electrical and gas supplies need
connecting.
PROPANE GAS SUPPLY
These heaters are designed for use with PROPANE GAS ONLY. Gas bottles are
not supplied, but are readily available from builders merchants or gas
suppliers etc.
This range of portable, direct fired gas heaters is designed to BS 4096 for
industrial applications to give safe, efficient and reliable operation, and are
for use with
Propane Gas only. Propane gas bottles are not supplied with the
unit, but are readily available from builders merchants or gas suppliers.
As with all mechanical equipment, optimum performance will only be
achieved if the correct application and servicing procedures are followed.
GAS CONNECTION
Connect the free end of the gas hose to the gas inlet connection on the
heater and tighten to ensure there are no gas leaks. Before attaching the
regulator to the gas cylinder, ensure the mating parts are free from grease
and dirt and are undamaged.
Fit the regulator to the cylinder,
tightening the thread as tight as
possible with a propane spanner,
noting that the threads are LEFT
HANDED. To check for leaks, use
soapy water or liquid soap.
IMPORTANT: The gas hose and
cylinder must ALWAYS be located
behind the heater.
In order to reduce the risk of icing up when operating at long periods at
maximum capacity, you should use a larger capacity gas bottle, or two/three
bottles in parallel, as shown in Fig 2.
The‘Tee’ piece and‘pigtails’are readily available from your builders
merchants or gas supplier.
WARNING
Propane Gas cylinders must be used and stored in accordance with the
‘Highly Flammable Liquids and Liquefied Petroleum Gases Regulations 1972 ’
FIG 2