14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
GENERAL MAINTENANCE
Make sure that all components are tight and secure.
Always have any damaged or worn parts repaired or replaced by qualified
service personnel. Do not attempt to repair the grinder unless you are qualified
to do so.
The drive motor and bearings are sealed units and require no regular
maintenance. Should you require assistance, contact your local Clarke
service agent.
The honing wheel may develop a bump after extensive use where the glued
joint in the leather covering stands proud as the leather becomes
compressed. The can be corrected by sanding away the high spot with an
abrasive (sandpaper) block.
The stone will wear down with use and may well go out of true. Use a dressing
wheel or stone grader to correct the trueness and to remove worn, glazed
grains from the stone.
The stone will have a finite life expectancy, dependant upon the nature of the
work being done. Periodically, make a note of the wheel diameter and
replace your 8” (200mm) dia wheel if it reduces to an little as 7”(180mm) in
diameter.
INSTALLING A NEW GRINDING STONE
1. Unscrew and remove the locknut
and washer that secures the stone
in place.
2. Remove the old grinding stone
and fit the replacement, securing
it with the locknut and washer.
Grasp the honing wheel to
prevent the drive shaft from
turning while tightening the nut.
DRESSING A NEW STONE
New grinding stones are frequently not true or in time can become grooved,
glazed (built-up), out of round or otherwise mis-shapen. To correct these
defects, a grinding stone dresser is available from your Clarke dealer.
ET125 Grinding Wheel Dresser - Part No:1700225
Replacement Dresser Wheel - Part No:1700230
Содержание CWS200B
Страница 20: ......