10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
5. To start/stop the grinder, press the
ON/OFF switch.
• The grinder can run either
forwards or backwards,
selectable via a 3-position
rocker switch.
Press the switch ‘up’ for reverse
rotation (anti-clockwise when viewed
from the grinding wheel end).
Press the switch ‘down’ for forward
rotation (clockwise when viewed from the grinding wheel end).
6. Distribute the abrasive paste
evenly onto the honing wheel
with a suitable tool as shown.
7. This should be sufficient for five to
ten tool honing tasks. This process
should be repeated as required to
ensure the long life of the honing
wheel and achieve a good finish.
USING YOUR GRINDER
GETTING STARTED
The tool support can be used to support the tool clamp or be used for
freehand grinding of any tools such as axes, pocket knives or woodcarving
chisels that will not fit into the available tool holders.
USING THE TOOL CLAMP
The tool clamp is designed for sharpening chisels and plane blades etc. When
using the tool holder proceed as follows.
WARNING: FRAGMENTS FROM A BROKEN/DETACHED GRINDING WHEEL
CAN CAUSE INJURY.
WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT
CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL OF
THE TOOL BEING GROUND.
WARNING: THE STONE WILL CONTINUE TO ROTATE BRIEFLY AFTER THE
SWITCH HAS BEEN PRESSED.
Содержание CWS200B
Страница 20: ......