13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
securing the tool with the tool clamp or tool holder, and setting the
honing angle to the angle used when grinding the tool.
• Press the tool evenly onto the honing wheel near the cutting edge,
and move the tool sideways across the wheel. Ensure that at least
half the width of the cutting edge comes into contact with the
wheel at any time to avoid damage to the wheel.
• Allow the wheel to do the honing, without applying excessive
downward pressure on the tool.
• Always ensure the honing wheel is kept saturated with machine oil
and abrasive paste for best results.
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Grinder will not
operate.
No power supply.
Check supply & rectify.
ON/OFF switch is
faulty.
Consult your CLARKE dealer.
Fuse blown.
Check & replace if necessary.
Consult your dealer if condition
persists.
Motor faulty.
Consult your CLARKE dealer.
Motor runs but
wheel not
spinning.
Retaining nut not tight.
Ensure wheel is correctly seated.
Tighten retaining nut. See Mainte-
nance on page 14.
Honing wheel not
engaged with drive
pin.
Loosen wheel & engage wheel
on drive pin. See page 15.
Motor gets too
hot.
Wrong supply voltage.
Ensure supply voltage is correct.
Work load too heavy.
Reduce pressure applied to work-
piece.
Unusual vibration
while working.
Grindstone mounted
incorrectly or dam-
aged.
Check & rectify. Replace grinding
wheel immediately.
Bearings badly worn.
Consult your CLARKE dealer.
Содержание CWS200B
Страница 20: ......