10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ATTACH THE LEG KIT TO THE TABLE SAW
1. Attach each leg to a corner of
the table saw using two of the M6
x 16 bolts, washers and spring
washers supplied.
• Note that one of the bolts also
passes through the brace.
2. Fit the rubber feet to the legs.
3. Attach the cross members to the
legs using 16 of the M6 x 12 bolts,
washers and nuts supplied.
• The long cross members are
placed front and rear.
• The short cross members are
placed on the sides.
4. Attach the stabilisers to the rear
legs using two of the M6 x 12 bolts,
washers and nuts supplied.
5. Check that all bolts are tightened
and then turn the table saw over
onto the feet.
