Clarke CTS11, Инструкция по эксплуатации и обслуживанию

Страница: 19 / 32

19
Overload Cut-Out
Your machine also features an overload cut-out device, so that if the machine is overloaded (due to
feed pressure being too great, a dull blade or low voltage etc.), the overload relay will intervene and
the motor will automatically cut out. In this event:
a. Disconnect from the mains supply.
b. Allow the motor to cool for at least five minutes.
c. Push the reset button, adjacent to the ON/OFF switches, which resets the overload
device.
d. Plug the machine back into the mains supply, and switch the saw back on.
WARNING!
THE MACHINE MUST BE IN THE OFF POSITION, AND THE PLUG REMOVED FROM THE POWER
SOURCE WHILST COOLING DOWN TAKES PLACE. THIS PREVENTS ACCIDENTAL STARTING WHEN
THE RESET BUTTON IS PUSHED, AS THE NO VOLT RELEASE WILL NOT HAVE TRIPPED .
ADJUSTMENTS
Changing The Blade Height
Turn the blade height handle to adjust the height of
the blade.
•
Rotate the blade height adjuster clockwise to
lower the blade.
•
Rotate the blade height adjuster
anticlockwise to raise the blade.
Changing The Blade Angle (Bevel Cutting)
Turn the blade angle adjustment dial to adjust the
angle of the blade ( 0-45 degrees ).
1. Loosen, the blade angle locking knob.
•
Rotate the blade angle adjuster clockwise to
increase the angle.
•
Rotate the blade angle adjuster anticlockwise
to decrease the angle.
2. Tighten the blade angle locking knob.