Clarke CTS11, Инструкция по эксплуатации и обслуживанию

Страница: 16 / 32

16
MOUNTING THE SAW
IMPORTANT
If the saw is to be a permanent fixture, ensure it is sited in an area with adequate
illumination and power supply.
DO NOT place it where you will be working in your own shadow, or where extension
cables are required - these are hazardous in a workshop environment.
If the table saw is to be used in a permanent location, it should
be fastened securely to a firm supporting surface such as a
stand or workbench, using the four mounting holes in the base.
A Floor Stand, specially designed for your CTS11 Table Saw is
available from your CLARKE dealer .
Holes should be drilled through the supporting surface of the
workbench using the dimensions illustrated and the machine
should be bolted down firmly.
If a VACUUM DUST EXTRACTION device is not to be used, an
opening MUST also be made in the workbench, the same size as
the opening in the bottom of the saw. (which houses the Bottom
Grid). This is in order to allow the saw dust to drop through.
Dimensions of the opening are shown in Fig.12.
IMPORTANT
Ensure the Bottom Grid is in place when bolting the machine to the workbench.
1. Each of the four mounting holes should be bolted securely using 8mm bolts (not included) which
should be 12mm longer than the thickness of the bench top.
2. Locate and mark where the saw is to be mounted.
3. Drill four (4) 10mm diameter holes through workbench.
4. Place the table saw on the workbench aligning the holes in the base with the holes drilled in the
workbench.
5. Insert four (4) 8mm bolts and tighten.
Mounting to Plywood
An alternative method of securing your table saw is to fasten the saw base to a mounting board,
600x600mm minimum size, to prevent the saw from tipping whilst in use. A good grade of plywood with
a minimum thickness of 19mm is recommended.
1. Follow the instructions for mounting to a workbench, substituting a plywood board with a minimum
size of 600x600mm.
The opening in the board should be the same as that shown in the diagram above.
To secure the table saw to the plywood board use 8mm countersunk screws with lock washers and
hex nuts (not included). Screw length must be at least 12mm more than the thickness of the
mounting board.
419mm (16.5”)
330mm (13”)
286mm (11.25”)
305mm (12”)
opening
in bottom
of saw
Mounting Holes
Fig.12