Clarke CSS400C, Инструкция по эксплуатации и техническому обслуживанию

Страница: 20 / 24

20
REPLACE CARBON BRUSHES
Your saw has externally accessible carbon brushes that should be checked
periodically for wear.
1. Using a flat blade screwdriver,
remove the top brush assembly
cap from the top of the motor.
2. Gently pry the brush assembly out
using a small screwdriver.
3. The second carbon brush can be
accessed through the access port
on the bottom of the motor.
Remove this in the same way.
• If either of the brushes are
shorter than 1/4 in. (6 mm), replace both brushes as a pair.
4. Make sure the brush cap is positioned correctly (straight). Tighten the
carbon brush cap using a hand screwdriver only. Do not overtighten.
REPLACING THE FLEXIBLE SHAFT DRIVE BELT
• Replacement belts are available from your Clarke dealer Part
number AWNCSS400C095
1. Remove the 3 screws securing the
belt cover.
2. Pull the cover away from the
machine.
3. Remove the old worn belt and
discard it safely.
4. Place the new belt over the small
gear then the larger gear you
may need to rotate the larger
gear by hand to do this.
5. Replace the cover and screws.
WARNING: TURN OFF AND UNPLUG THE SAW BEFORE CARRYING OUT ANY
MAINTENANCE WORK ON YOUR SCROLL SAW.