Clarke CSS400C, Инструкция по эксплуатации и техническому обслуживанию

Страница: 16 / 24

16
STACK CUTTING
Stack cutting may be used when several identical shapes need to be cut.
Several workpieces may be stacked one on top of the other and secured to
each other before cutting.
Pieces of wood may be joined together by placing double sided tape
between each piece or by wrapping tape around the corners or ends of the
stacked wood.
The stacked pieces must be attached to each other in such a way that they
can be handled on the table as a single workpiece.
WHAT TO DO IF THE SAW BLADE JAMS IN THE WORKPIECE
When withdrawing the workpiece, the blade may bind in the kerf (cut). This is
usually caused by sawdust clogging the kerf or by the blade coming out of
the blade holders. If this happens:
1. Place the switch in the OFF position.
2. Wait until the saw has stopped and unplug it from the power source.
3. Remove the blade and the workpiece.
Wedge the kerf open with a small flat screwdriver or wooden wedge then
remove the blade from the workpiece.
WARNING: TO AVOID SERIOUS PERSONAL INJURY, DO NOT CUT SEVERAL
WORKPIECES AT A TIME UNLESS THEY ARE PROPERLY ATTACHED TO EACH
OTHER.