8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE NOTES
• Be aware that factors other than the tool may effect its operation
and efficiency such as reduced compressor output, excessive drain
on the airline, moisture or restrictions in the line, or the use of
connectors of improper size or poor condition which will reduce air
supply.
• Grit or gum deposits in the tool may also reduce efficiency. This
condition can be corrected by cleaning the air strainer and flushing
out the tool with gum solvent oil, or failing this, the tool should be
disassembled, thoroughly cleaned, dried and reassembled.
• If the tool runs erratically or becomes inefficient, and the air supply is
sound, dismantle the piston assembly and replace worn or
damaged parts, or take the tool to your CLARKE dealer.
• The use of parts other than CLARKE replacement parts may result in
safely hazards, decreased tool performance and will invalidate your
warranty.
SPECIFICATION
Type Of Tool
CSN-1D
Dimensions
255 x 54 x 252 mm
Weight (Without Fasteners)
2.24 kg
Activation Mode
Single sequential
Drive Speed
90 (shots/min)
Compressed Air
Maximum Allowable Pressure
120 psi /8.3 bar
Recommended Allowable Pressure Range
60 - 100 psi /4.14 - 6.9 bar
Noise Characteristic Values In Accordance With EN12549.
Sound Pressure:
88.7 dB(A)
Sound Power Measured LwA
101.7 dBLwA
Vibration Characteristic Values In
Accordance With ISO 8662-1 1: 1999
<2.5 m/s
2
