9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
11. Fit the fence feather boards as
shown in Fig. 7 using the fixings
supplied (hex head bolt x 4,
washer x 4 and knob x 4. Pay
attention to the feed direction.
12. Fit the table feather board as
shown in Fig. 7 using the fixings
supplied; again pay attention to
the feed direction.
13. Insert the two hex head bolts from
the underside of the table pictured
in Fig. 8a, place spacers on the
bolts ensuring the correct
orientation, place the feather
board on top, place washer on
each bolt and secure with knobs.
Fig. 8b.
• DO NOT overtighten.
14. Fit the switch assembly as follows.
• Unwrap the power cable.
• Fit in position, see Fig. 9 with two
phillips head screws inserted
from the front of the table
secured with two washers and
locknuts, (supplied).
• DO NOT overtighten
MOUNTING THE ROUTER
1. Loosen the fence securing knobs
and slide the fence forward as far
as possible. This prevents the router
clamping bolts (50mm coachbolts)
from falling through the table
when it is turned over.
2. Carefully turn the table assy over
and support it by laying it on
suitable sized blocks of wood or
similar. see Fig. 10.
Содержание CRT1
Страница 20: ......