11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
When making adjustments etc, always ensure the router is isolated from the
electrical supply by switching off and removing the plug from the socket.
NOTE:
Always refer to the specific router operating instruction manual
when making height and speed adjustments etc.
INSTALLING THE ROUTER CUTTER (BIT)
To install bits whilst the router is in situ will require the router to be lowered fully.
Select the desired bit and install. Fit the table insert closest to the size of the bit,
ensuring the bit does not touch the insert.
HEIGHT ADJUSTMENT
Raise the router until the bit protrudes through the table the required amount.
When making height adjustments, ensure the cutter does not touch the
transparent retractable guard. Operate the guard manually and check that
the guard moves freely.
Make test cuts on scrap pieces of wood to set the router accurately.
FENCE ADJUSTMENT
Loosen the two fence clamping knobs and position the fence as desired, use
the graduation marks to set the fence parallel, see Fig. 6.
Make test cuts on scrap pieces of wood to set the router accurately.
FEATHER BOARDS
Set the fence feather boards to hold the piece of wood flat on the table and
against the fence whilst machining.
To do this, place the piece of wood against the fence and below the relevant
pad to be adjusted. Loosen the two wingnuts and lower the pad until it rests
on the wood, push the pad down a little further to apply sufficient pressure to
hold the wood flat on the table.
Repeat the above procedure for the other fence board.
Adjust the table feather board in the same manner to hold the wood firmly
against the fence.
JOINTING FENCE
Set the jointing fence to support the wood when cutting the full thickness.
Adjust the cutting depth etc as previously described. Proceed to machine the
piece of wood until the leading edge passes over the jointing fence by
approx 25mm (1”). Switch off and isolate from the electrical supply. Hold the
wood firmly against the fence, loosen the jointing fence clamping knob and
Содержание CRT1
Страница 20: ......