Clarke CRD1250, Инструкция пользователя

Страница: 10 / 14

SETUP AND OPERATION CONTINUED
• DRILL STOP:
For chiselling it is necessary to deactivate the drilling action as follows:
Turn the hammer control switch (7) to the position marked: .
Depress the lock pin (9) then turn the drill control (8) so that the position marked:
coincides with the arrow on the machines case.
• HAMMER AND DRILL:
To activate the hammer and drill mode turn the hammer control switch (7)
to the position marked: . Depress the lock pin (9) and turn the drill
control (8) so that the position marked: coincides with the arrow on the
machines case.
IMPORTANT!
When hammer drilling you only need to apply light pressure. Too much
pressure will place unnecessary load on the motor. Check the drill bits
regularly, re-sharpen or replace.
MAINTENANCE
• ALWAYS ensure the tool is isolated from the electrical supply, by switching
OFF and removing the plug from the 13 amp socket before commencing
any maintenance activities or adjustments etc.
• Clean the tool regularly, use a soft brush and or soft cleaning cloth. DO NOT
use any chemicals or harsh abrasives to clean the tool.
• At the end of work, to prevent dust deposits you should use a compressed
air (max.3 bar) to clean out the ventilation holes.
• Remove and inspect the carbon brushes regularly, it is very important to refit
the motor brushes exactly as they are removed, DO NOT turn them around
or swap their positions (dirty or worn carbon brushes result in excessive
sparking and speed faults).
• Always replace the motor brushes in pairs.
• Check gearbox regularly and top up if necessary with a good quality high
melting point gearbox grease. DO NOT overfill the gearbox, apply sufficient
grease to cover all visible moving parts. (fig.2 refers to grease cover).
WARNING: The use of spare parts or accessories, other than those supplied
by CLARKE international or one of its recognised dealers, may be
hazardous and could invalidate the guarantee.
- 9 -