12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
Before commencing any maintenance procedures, always ensure the drill is
isolated from the electrical supply by switching off and removing the plug
from the socket.
BEFORE USE
1. Ensure all fixing screws remain tight to ensure the drill is in safe working
condition.
2. Inspect the power cable to ensure it is free from cracks, bare wires etc.
CLEANING
1. Ensure all air ventilation slots are clear of blockages, (use compressed air to
clean the machine if possible).
2. After use, clean all dust and swarf from the drill.
3. Clean the exterior of the drill with a soft cleaning cloth. Never use any
chemicals or harsh abrasives to clean the tool.
• Avoid using solvents when cleaning plastic parts; most plastics are
susceptible to damage from various types of commercial solvents.
GENERAL MAINTENANCE
After extensive use, grease may be
added to the hammer drill
mechanism via the maintenance
apperture provided.
Remove the cover using the wrench
supplied as shown, and add a
smearing of grease to the moving
parts.
• All other bearings etc, in this
tool are lubricated with
sufficient high grade lubricant for the tools lifetime under normal
operating conditions, therefore no further lubrication is necessary.
• There are no other user servicable parts in this machine. Refer to your
CLARKE dealer if internal maintenance is required.
WARNING: MAKE SURE THAT THE DRILL IS SWITCHED OFF AND
DISCONNECTED FROM THE MAINS SUPPLY BEFORE STARTING ANY
CLEANING OR MAINTENANCE PROCEDURES.
