Clarke CMS210, Инструкция по эксплуатации и техническому обслуживанию

Страница: 13 / 24

13
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MITRE CROSS-CUT
1. Release the table mitre lock and
move the arm left or right to the
required angle.
2. Lock in position by tightening the
table mitre lock.
• Always ensure that the table
mitre lock is securely tightened
before cutting.
• Allow the blade to cut freely.
Do not force the tool.
• Proceed as for a vertical straight cross-cut.
NOTE: When you mitre the end of a piece of wood with a small off-cut, Place
the wood so that the off-cut is to the side of the blade with the greater
angle to the fence.
BEVEL CUTS
Bevel angles can be set from 45° left to vertical and can be cut with the mitre
arm set between zero and a maximum of 45° right or left.
1. Loosen the bevel adjustment
handle and set the bevel at the
desired angle.
2. Tighten the bevel adjustment
knob firmly.
3. Proceed as for a vertical straight
cross-cut.
• Allow the blade to cut freely.
Do not force the tool.
MITRE / BEVEL CUTS
As the number of sides the workpiece has changes, so do the mitre and bevel
angles. The chart below gives the cutting angles for a variety of shapes,
assuming that all sides are of equal length.
No. of sides Angle mitre or bevel
4 45°
5 36°
6 30°
8 22.5°
10 18°